[ 1.00.34] - added the function for cleaning by using the buttons on the front of printer after opening the top cover [ 1.00.31 ] - modified the downloading block size (1KB to 2KB) when the laminator firmware is being downloaded and updated (from the printer firmware ver. 1.10.47). - modified the laminator firmware is downloaded again from the start address when the laminator firmware's downloading and updating is failed (from the printer firmware ver. 1.10.47). [ 1.00.28 ] - fixed to adjust the flipper position again when card is moved into the laminator and card is ejected to the front side of the printer. - changed to enable to recognize the film under the condition that the width of division mark on laminating film is over 2mm (minimum). - changed that laminating is started when the laminator head's temperature is same with the setting temperature. - changed that the card is accelerated every second when the card is being ejected. [ 1.00.22 ] - changed to prohibit the overheating of Laminator head - added the error bits to check the overheating of Laminator head "E_HEAD_SAFETY (0x00040000)" - changed to routine of card-in action when bottom card in-> Laminating -> Back out movements in pipeline mode [ 1.00.20 ] - fixed the minor bugs [ 1.00.18 ] - added the value of flipper angle to be changed by end-user (Rotator Pos. range: -20 ~ 20) - added the commands between Printer and Laminator (ex. the command to change the status) - changed the routine of returning a card in Laminator - changed the routine of angle adjustment in flipper of Laminator [ 1.00.11 ] - fixed the bug of laminating on top side when commanding to laminate on bottom side in pipeline mode [ 1.00.09 ] - changed to stop the printer and display the error message at LCD when error occurs in Laminator [ 1.00.06 ] - improved the card transport method of Laminator